Card centering tool
Measure a card's left/right and top/bottom centering against PSA's stated tolerance for a 10: it measures centering only and is not a grade. Your photo never leaves your browser.
Measure a card
Lay the card flat on a plain surface, fill the frame and avoid glare. For a steady result the card should be at least about 1,000 pixels across in the photo.
You can also drop a picture here, or paste one.
Your photo stays in this browser. Nothing is uploaded and nothing is saved.
Try a drawn sample card
The samples are drawn by this page: plain stand-in cards with a known centering, not real cards. After you measure one, the result shows the ratios it was drawn with.
Step 1: straighten the card
Drag the four round handles so the yellow lines run along the card's edges.
Step 2: place the eight guides
Solid lines go on the card's edges, dashed lines where the border meets the print.
For cards with art to the edge: there is no border to measure, so the tool shows no ratio.
More help
Step 1, the frame
Cards have rounded corners: line up the straight edges, not the rounded tips. Straightening makes a photo taken at a slight angle measure like one taken square-on.
A focused handle moves with the arrow keys: one pixel, ten with Shift, a quarter pixel with Alt.
A hand-held photo is almost never square-on, and a tilt of a few degrees moves the result by a point or more. Skip only for a scan or a picture taken exactly square to the card.
Step 2, the guides
Drag a line or its tab, or pick a guide under the picture and move it with − and +. Tapping a tab or a guide under the picture only picks it. A guide counts as placed once you move it or snap it; if it already sits right, pick it and press "It is on the edge" under the picture. Guides still at their starting position are faded, with a striped tab.
- Solid line, filled tab: outer guide, on the card's edge
- Dashed line, outlined tab: inner guide, where the border meets the print
A focused tab moves with the arrow keys: one pixel, ten with Shift or Page Up and Page Down, a quarter pixel with Alt or Ctrl. Home and End go to the ends. Enter or Space accepts a guide where it is, like "It is on the edge". Ctrl+Z undoes the last change.
Under the picture, pick a guide, then move it one picture pixel at a time with − and +. Snap looks for the nearest edge within a few pixels and moves the guide only when it finds a clear one.
An edge search on the picture. It places guides only when it is confident, and they still need checking by eye.
Zoom
Pinch with two fingers, use the zoom buttons, or hold Ctrl and scroll to zoom. When zoomed in, drag the picture to move it.
Result
Before you measure
- It measures centering only. It does not grade a card and does not predict a grade.
- PSA says a grader may allow a small variance for a card's overall eye appeal, so a measurement near the limit cannot tell you what a grader will decide.
- Cards with art to the edge have no border to measure. The tool says so instead of guessing.
- Your photo never leaves your browser. It is drawn on your screen and is not uploaded anywhere.
PSA's tolerance for a 10
Front, at most55/45
Back, at most75/25
PSA's wording for PSA 10: "approximately 55/45 percent on the front, and 75/25 percent on the reverse". PSA writes "approximately". The worse of the two axes decides.
Read on November 16, 2026 on PSA's grading standards.
Every grade's tolerance is on the data page.
How to use it
- Take a photo of the card straight on, or pick one you already have. Lay the card flat, fill the frame and avoid glare.
- Move the four outer guides to the card's edges.
- Move the four inner guides to the inside edge of the printed border.
- Read the left/right and top/bottom ratios, and whether each is inside PSA's stated tolerance for a 10.
- Do the back too if you like: PSA's tolerance for the back is wider.
Wondering whether a card is worth sending at all? The grading cost calculator shows PSA's fees with the date they were read.